Maintenance Works; After Use; Grass Catcher; Transportation - IKRA IEVL 1400 Instrucciones De Manejo

been balanced correctly or has suffered deforma-
tion due to impacts. In this case it must be repaired
or replaced.

11. MAINTENANCE WORKS

1. Unscrew the screw (1) from the bearing)
2. Flap up the bearing half (3)
3.
pull it out from the drive side (2).
To re-assemble proceed in reserve order.
Note:
Before disassembling the blade look at its mount-
ing position
1. Unscrew the hexagon bolt (1).
2. Carefully remove the ball bearing (2) from the shaft (8)
3. Remove pressure ring (3), disk (4) and short distance
sleeve (5) from the shaft.
4. Successively remove blade (6) and long distance
sleeves.
To re-assemble proceed in reserve order.
The disassembly of the aerator roller must be

After use

1. Switch the product off, disconnect it from the power
supply and let it cool down.
2. Check, clean and store the product as described be-
low.
Fault
Motor does not run
Roller does not rotate
Motor output drops
Poor scarifying perfomance
Noisy running, application vibrates
(workshop).
GB | Operating Instructions
(picture F)
(picture G)
Cause
No voltage
Roller blocked
Toothed belt defective
Working depth too high
Dirty housing
Lawn too long for scarifying
Working depth too high
Worn blades
Balde damaged

Grass catcher

1. Inspect the grass catcher before each use. Do not
2. Clean the grass catcher after operation. Let the grass
catcher dry thoroughly before storing to avoid mildew.

Transportation

1. Switch the product off and disconnect it from power
supply before transporting it anywhere.
2. Attach transportation guards, if applicable.
3. Adjust the cutting depth to the transportation stage.
4. Always transport the product by its handle.
5. Protect the product from any heavy impact or strong
vibrations which may occur during transportation in
vehicles.
6. Secure the product to prevent it from slipping or fall-
ing over.

12. TROUBLESHOOTING

WARNING! Only perform the steps described in
these instructions! All further inspection, main-
tenance and repair work must be performed by
problem cannot be solved by yourself!
WARNING! If the product does not perform prop-
erly, or sound are abnormal, or motor cannot be
started, or stopped as described, or the cutting
device does not work properly, or any other ir-
regularity, or malfunction occurs, do not attempt
to repair the product by yourself.
Please contact helpline or service center.
Before carrying out any maintenance opera-
tions, cut off the electric power supply by dis-
connecting the plug from the extension cable.
Remedy
Check connection line and connec-
tion protection switch
Check roller
Workshop
Selected lower working depth
Clean housing
Lawn too long for scarifying
Select lower working depth
Replace worn blade
Workshop
GB-9