Remote Control Operation - NEO STEAM F700 Manual De Usuario

seconds without operation back to idLE or cLn_.

Remote Control Operation

For best result, use VT-1 puff volume adjustable
controller
1. Firmly attach the remote control to socket (Fig-
ure1-K) on the back of the unit
2. Displays the previous picture, fogging con-
trolled by display stops working, puff volume
controlled by VT-1;
3. Refer to your controller manual for controller
operation details (Appendix A );
VT-1 only control the puff volume, Fan still controlled
by display. Press UP/DOWN on the panel to adjust
Fan, displays F.xxx , 2 seconds without operation,
back to P.xxx. Press MENU to check current Fan value,
displays F.xxx, 2 seconds without operation, back to
P.xxx .
DMX Control Operation
1. Connect the DMX 512 controller cable to the
input socket (Figure 1-I) of the fog machine
unit. Make sure the signal cable polarity is cor-
rect. When DMX socket receives effective DMX
signals, the machine enter DMX control mode
automatically
2. There are 2 DMX channel machine, refer to DMX
channel chart in Figure 2 make related settings
3. Interchange puff volume "P.xxx" / Fan volume
"F.xxx", every 3 seconds
4. "A.xxx" Press MENU to check current DMX ad-
dress, press UP/DOWN to set DMX address;
5. After 3 seconds without operation, back to
interchange of puff volume "P.xxx"/ Fan volume
"F.xxx"
6. "P.xxx" Displays current puff volume is con-
trolled by DMX;
7. "F.xxx" Displays current fan volume is con-
trolled by DMX;
8. If desired, connect another faze machine: Plug
one end of another signal cable in to the output
P. 12
Neo Steam F700 - English version
socket (Figure 1-J) on the back of the
first Steam F700; plug the other end of the
signal cable to the input socket (Figure 1-I) on
the back of the second Steam F700. Follow the
same procedure to link more fog machine, if
desired; whole link is daisy chain.
9. Down. Refer to DMX channel chart in Figure 2
make related settings. Now start operating
Steam F700 with DMX console.
Under idLE or cLn_. status, still can operate the
machine, press MENU button to check and set
numbers.
REMARK To reduce the possibility of that the
wind mouth gets humid, the software will detect
the wind value and the fog value, and do proper
adjustment. Under display control mode (timing
fogging, continuous fogging and manual fogging)
or DMX control mode: when fog value is adjusted
to 100%, the software will adjust wind value(even
it is set at 5%) to 30% automatically; when wind
value is adjusted to 5%, the software will reduce
fog value to 50% automatically. This will prevent
the smoke vent from getting humid because of
too small wind but too much fog. * Fog value =
Volume, wind value = Fan