General Outline; Manual Manoeuvre - BFT STOPPY Instrucciones De Uso

ENGLISH
Thank you for buying this product, our company is sure that you will be
more than satisfied with its performance. This product is supplied with
a "Warnings" leaflet and an "Instruction Manual". These should both
be read carefully as they provide important information about safety,
installation, operation and maintenance. This product complies with
recognised technical standards and safety regulations. We declare that
it is in conformity with the following European Directives: 2004/108/EEC,
2006/108/EEC, 98/37/EEC (and subsequent amendments).

1) GENERAL OUTLINE

Underground anti-waiting bollard, compact and sturdy.
It consists of a steel rod coated with reflecting material, and powered
by an oil-bath motor; all protected by a hot-galvanised steel cylinder
which is fitted underground.
The PERSEO N control panel allows up to four bollards to be controlled
simultaneously.
Besides the standard version, STOPPY is available in the following
models: "L" series provided with signal indication blinker lights and,
on request, "R" series provided with a heated resistor which also allows
the bollard to be used in particularly cold climates (as much as –25°C)
and "A" series provided with a magnetic sensor for connection to an
antitheft system.
Accessories:
Electric brake buffer battery kit, which allows the bollard to be kept in
the access closed position even when the mains power is off.
2) SAFETY
If correctly installed and used, this automation device satisfies the re-
quired safety level standards. However, it is advisable to observe some
practical rules in order to avoid accidental problems.
Before using the automation device, carefully read the operation instruc-
tions and keep them for future reference.
• Keep children, persons and things outside the automation working
range, particularly during operation.
• Keep radio controls or other control devices out of children's reach,
in order to avoid any unintentional automation activation.
• Do not intentionally oppose the rod movement.
• Do not modify the automation components.
• In case of malfunction, activate the cut-out switches to disconnect
the power supply, batteries included, in order to gain access to the
automation device, and request the assistance of a qualified person
(installer).
• Before proceeding to any external cleaning operation, activate the
cut-out switches to disconnect the mains powers supply and the
batteries, if provided.
• Keep the photocell optical components and light signal devices clean.
Check that none of the safety devices (photocells) are obscured by
branches or shrubs.
• For any direct assistance to the automation system, request the help
of a qualified person (installer).
• Have qualified personnel inspect the automation system once a
year.

3) MANUAL MANOEUVRE

When the power supply is disconnected, the bollard tends to lower
spontaneously, therefore carrying out an opening manoeuvre; a simple
pressure exerted on the top of the cylinder surface will complete lower-
ing, and vehicle transit will be allowed. See fig. 1.
N.B. opening means bollard lowered (transit allowed), closing means
bollard raised (transit not allowed)
In the case of bollards provided with buffer batteries, before proceed-
ing to manual manoeuvre, disconnect the emergency power supply by
means of the appropriate switch fitted by the installer.
4) MAINTENANCE AND SCRAPPING
System maintenance is to be regularly carried out by qualified person-
nel. The materials making up the appliance and its packing are to be
scrapped according to current standards. Batteries must be disposed
of in the appropriate manner.
WARNING
Correct operation of the controller is only guaranteed when the data
specified in this manual are respected, as well as good technical
practice standards. The Company cannot be held responsible for
4 -
STOPPY - Ver. 10
USER'S MANUAL
any damage caused by failure to observe the installation standards,
good technical practice standards and directives specified in the
present manual.
The descriptions and illustrations contained in the present manual
are not binding. The Company reserves the right to make any al-
terations deemed appropriate for the technical, manufacturing and
commercial improvement of the product at any time, while leaving
the essential product features unchanged.
Fig. 1