Assembly; Installing The Disc Table; Installing The Flex Shaft (Optional Accessory) - Dremel 1800 Manual De Instrucciones

Installing the Disc Table & Guard
Refer to Figure 4.
Assemble the side table and guard, using two wing knobs,
large spacers, flat head screws, and o-rings. Put spacers on
wing knobs, then insert through sliding scales on sides of table
and screw into bottom holes in base. Next, insert flat head
screws through clear plastic guard, then though o-rings and
tighten into top holes on table and base. Adjust table to
desired angle and tighten wing knobs.
Installing the Flex Shaft
(Optional Accessory - Model 225)
The optional flex shaft is used mainly for drilling pilot holes
when making interior scroll cuts (see OPERATION) or for
sanding. Also refer to the manual supplied with the Flex
Shaft.
Refer to Figure 5.
1. Remove the two Phillips head mounting screws and
wing knobs securing the side table to the guard.
2. Remove the Phillips head screw securing the disc to the
motor and remove the disc.
3. Insert the drive screw (supplied with the Scroll Station)
into the end of the motor shaft and tighten securely.
4. Insert square cable through the square hole in the drive
screw and fully into the motor shaft.
5. Secure the flex shaft to the motor shaft and tighten
securely.
6. Flex shaft should be disconnected from the motor shaft
before sawing is performed.
Flex shaft must be stored in holder when
WARNING
!
attached and not in use.
Do not engage shaft lock on handpiece while
WARNING
!
motor is running.
A A s s s s e e m m b b l l y y
11
Figure 4. Installing the Side Table
Flex Shaft Holder
Drive Nut
Figure 5. Installing the Flex Shaft
(optional accessory)