Installation; Recommended Hand Tools; Feet Installation; Re-Route The Drain Hose - Classeq P500 Manual De Usuario

Classeq Pass Through Range - User Manual

4. Installation

Warning!
The installer and user are responsible for
ensuring the installation and operation of this
warewasher are in accordance with this manual
and with local and national regulations.
4.1

Recommended Hand Tools

The following hand tools are required when installing the
warewasher:
 Spirit level
8mm / 10mm spanner

Multimeter or voltmeter

Insulated electric screw driver

 Drill with 8mm bit.
4.2

Feet Installation

For safety reasons, two persons are required
for the task.
It is very important that two persons are available in order to
install the feet to the warewasher.
Note: Person one supports the tilted warewasher and person
two installs 2 of the feet.
 Locate two feet and eight M6x20mm fasteners
Tilt the warewasher backwards supported by person

one.
Person two positions the front feet into place and finger

tightens the fasteners into place.
Using a 10mm spanner the feet fasteners are tightened

onto the warewasher.
 Once tightly secured the warewasher is pushed forward
supported by person one.
The procedure above is followed until the back feet are

fixed securely.
Two Persons Fixing Feet
Fixings for Feet
4.3

Re-route the Drain Hose

Once the feet have been fixed securely and the warewasher is
fully upright, find the Drain Hose and re-route it through the
Drain Grommet located on the base of the warewasher.
Locate the Drain Hose and re-route through the Drain Grommet
The Drain Hose re-routed through the Drain Grommet to be
connected to the site drain
4.4

Warewasher Placement

The warewasher should be installed on a flat, stable surface that
is capable of holding the full weight of the filled warewasher and
withstanding the vibration of regular use.
Ensure there is a minimum of 20mm clearance on each side of
the warewasher and 20 mm clearance at the rear of the
warewasher.
UK
7