Draining Down The Warewasher; Warewasher Malfunction - Classeq P500 Manual De Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 37
Classeq Pass Through Range - User Manual
6.9

Draining Down the Warewasher

Caution
It is very important the
down at the end of each working day.
During normal operation the warewasher will drain out any
excess water.
There are two ways to fully drain down the warewasher by lifting
the Hood up and down and via the control buttons, bothe require
the warewasher to be off.
Press the On/Off button (1) to turn OFF.
Lifting the Hood up and down
Lift up the Hood
The warewasher will drain
down the Wash Tank.
Via the control buttons
warewasher
is drained
Pull down the Hood
The warewasher will do a self-
rinse.
Press the On/Off button (1) to
turn OFF.
The Cycle indicator (3) will
flash blue.
Notes:
1.
Once empty, Classeq recommends that the mains
water and electricity supplies are turned off and
the warewasher is cleaned (►7.2).
2.
For hygiene reasons it is recommended that once
the warewasher has been drained and cleaned the
Hood is left open to assist in natural drying of the
Wash Chamber.
6.10

Warewasher Malfunction

In the event of a warewasher malfunction:
Switch the warewasher off using the On/Off button.
Isolate the electrical supply to the warewasher.
Turn off the water supply.
Request a service callout.
For further information please refer to the Troubleshooting
section (►8).
Press on the Cycle button (2).
When the Cycle indicator (3)
stops flashing the drain down
cycle is complete.
19
UK

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

P500aP500a wsP500asP500as ws

Tabla de contenido