Classeq P500 Manual De Usuario página 9

Classeq Pass Through Range - User Manual
Damage to the warewasher caused by limescale or poor
UK
water quality will NOT be covered by the Manufacturer's
Warranty (►7.3).
In hard water areas (>3°dH), DO NOT run the
warewasher without the use of either an internal or
external water softener as this could result in damage to
the warewasher. Failure to observe this warning will
invalidate the warranty.
Warewashers with WS in the model type are fitted with an
internal water softener.
DO NOT run the warewasher without salt in the Salt
Reservoir as this will allow limescale to build up.
Limescale deposits in the warewasher will invalidate the
warranty (►5.5) (►7.4.1).
Only use granulated salt (max. grain size 5 – 7 mm). Salt
tablets are not suitable (►5.5) (►7.4.1).
DO NOT add any chemicals, such as detergent or rinse
aid to the Salt Reservoir. These will cause damage to the
warewasher (►5.5) (►7.4.1).
Only use commercial grade detergents and rinse aids in
the warewasher (►4.9).
If the Salt Reservoir Cap is not properly secured, water
and/or chemicals can leak in or out of the unit causing
damage to the warewasher (►5.5) (►7.4.1).
Always remove excess food / debris from any dishes /
glasses to be washed. DO NOT use the warewasher as a
waste disposal unit (►6.8).
It is very important that the warewasher is drained down
at the end of each working day (►6.9).
DO NOT use STEEL WOOL, WIRE BRUSHES or any other
abrasive materials.
De-scale chemical must not remain in the warewasher for
more than 2 hours (►7.5).
DO NOT spray the exterior or interior of the warewasher
and the surrounding area (panels, base) using a water jet,
steam cleaner or high pressure cleaner.
The function of this warewasher is the washing of dishes,
plates, glassware, cutlery and similar articles only. No
other activity is permitted with this warewasher.
Authorised spare parts only must be used in the event of
a breakdown.
3