Safety Decals; Assembling Engine And Drive Shaft Assembly; Connecting Throttle Cable And Stop Switch Wires - Maruyama EH27D Manual Del Propietário

Safety Decals

ON SHAFT
(Part No. 217879)
Assembly

Assembling Engine and Drive Shaft Assembly

Attach the clutch drum housing to the engine using the four screws supplied
with the unit.

Connecting Throttle Cable and Stop Switch Wires

1. Loosen the knob and remove the air cleaner cover, insert the throttle cable
through the cabrburetor bracket, then screw a cable adjuster sleeve into the
carburetor bracket fully.
2. Position the slotted fitting on the carburetor so the recessed hole for the lug
is away from the cable adjuster sleeve.
3. Rotate the carburetor throttle cam and slip the throttle cable through the
slot in the slotted fitting, making sure the cable lug drops into the recessed
hole.
4. Operate the throttle trigger a few times to make sure that it works correctly.
Safety Decals are easily visible to the operator and are located near any
area of potential danger.
Replace any decal that is damaged or lost.
− US-12 −
Engine
Screw (4)
Clutch Drum Housing
Air Filter Cover
Matching Connectors
Cable Adjuster Sleeve
Throttle Cable
Carburetor
Bracket
Slotted Fitting
Locknut
Recessed Hole
Knob
Cable Lug