Startup; Starting Up The System; Operating Notes - Balluff BIP LD2-T017-04-BP Serie Manual De Instrucciones

BIP LD2-T017-04-BP _ _ / BP _ _ -S4
Inductive Positioning System
5

Startup

5.1

Starting up the system

DANGER
Uncontrolled system movement
When starting up, if the BIP inductive positioning system
is part of a closed loop system whose parameters have
not yet been set, the system may perform uncontrolled
movements. This could result in personal injury and
equipment damage.
► Persons must keep away from the system's
hazardous zones.
► Startup must be performed only by trained technical
personnel.
► Observe the safety instructions of the equipment or
system manufacturer.
1. Check connections for tightness and correct polarity.
Replace damaged connections.
2. Turn on the system.
3. Check measured values and adjustable parameters
and readjust the BIP inductive positioning system,
if necessary.
Check for the correct values at the null point
and end point, especially after replacing the BIP
or after repair by the manufacturer.
5.2

Operating notes

– Check the function of the BIP and all associated
components on a regular basis.
– Take the BIP out of operation whenever there is a
malfunction.
– Secure the system against unauthorized use.
8 english