Dometic SINEPOWER MSI 2312T Instrucciones De Montaje Y De Uso página 20

Connecting the inverter
9.7 Connecting the MCR7 or MCR9 remote control
(accessory)
A
NOTICE!
• Only plug in the connection to the remote control in the remote port.
The device can be damaged by connecting it incorrectly.
• Ensure that the remote control and inverter are supplied with the
same input voltage.
• Follow the instruction manual of the remote control.
➤ Connect the remote control (accessory) to the remote port (fig. 5 12, page 4).
9.8 Connect external switch to turn device on and off
I
NOTE
Use cables with a cable cross section of 0.25 – 0.75 mm².
You can use the following as an external switch:
• external switch, voltage supply from the inverter: fig. 8, page 6
• Control unit with relay or transistor circuit (TR): fig. 9, page 6
• external switch with voltage supply from the battery (BAT) of the vehicle: fig. 0,
page 6
• external switch with its own voltage supply (DC POWER) e.g. from the ignition:
fig. a, page 6
➤ Set the main switch (fig. 5 3, page 4) to "OFF" and make sure that the connec-
tion for the remote control (fig. 5 12, page 4) is not assigned.
➤ Set the main switch (fig. 5 3, page 4) to "REMOTE".
➤ Connect the external on/off switch with the connection cable to the green
terminal (fig. 5 11, page 4).
20
SinePower
EN