Aluminium Processing; Technical Data; Intended Use - Festool TS 55 REBQ Manual De Instrucciones Original

TS 55
GB
Sound pressure level
Noise level
Measuring uncertainty allow-
ance
CAUTION
Operating noise
Damage to hearing

Use ear protection!
Vibration emission value a
directions) and uncertainty K measured in accor-
dance with EN 60745:
Vibration emission level (3 directions)
Cutting wood
Cutting metal
Uncertainty
The specified emission values (vibration, noise)
– are used to compare machines.
– They are also used for making preliminary esti-
mates regarding vibration and noise loads during
operation.
– They represent the primary applications of the
power tool.
Increase possible for other applications, with other
insertion tools or if not maintained adequately. Take
note of idling and downtimes of machine!
2.4

Aluminium processing

When processing aluminium, the following
measures must be taken for safety reasons:
4

Technical data

Portable circular saw
Power
No-load speed
1
Max. speed
Inclination
Cutting depth at 0°
Cutting depth at 45°
Saw blade dimensions
Weight (without mains cable)
Safety class
1.
Max. possible speed with faulty electronics.
16
L = 89 dB(A)
PA
L = 100 dB(A)
WA
K = 3 dB
(vector sum for three
h
a < 2,5 m/s
h
a = 2,8 m/s
h
K = 1,5 m/s
TS 55REBQ,TS 55REQ
– Install an upstream residual-current circuit
breaker (FIG, PRCD).
– Connect the machine to a suitable dust extractor.
– Regularly remove dust deposits from the motor
housing.
– Use a aluminium saw blade.
– Close the viewing window/chipguard.
Wear protective goggles.
– When sawing panels, they must be lubricated
with paraffin but thin-walled profiles (up to 3
mm) can be sawed without lubrication.
3

Intended use

Plunge-cut saws are intended to be used for sawing
wood, materials similar to wood, plaster and ce-
ment-bonded fibre materials and plastics. When
2
fitted with special saw blades for aluminium of-
2
fered by Festool, these machines can also be used
2
for sawing aluminium.
Only saw blades with the following specifications
may be used: Saw blade diameter 160 mm, cutting
width 2,2 mm, location hole 20 mm, max. standard
blade thickness 1,8 mm, suitable for speeds up to
9500 rpm. Never use abrasive wheels in the ma-
chine.
The machine is designed and approved for use by
trained persons or specialists only.
– Festool electric power tools must only be in-
stalled on work tables provided by Festool for
this purpose. If the tool is installed in another, or
self-made, work table, it can become unstable
and result in serious accidents.
The user is liable for improper or non-in-
tended use.
1200 W
2000 - 5200 rpm
7300 rpm
-1° to 47°
0 - 55 mm
0 - 43 mm
160x2,2x20 mm
4,5 kg
/II
TS 55RQ
1050 W
6500 rpm
-1° to 47°
0 - 55 mm
0 - 43 mm
160x2,2x20 mm
4,4 kg
/II