Safety Measures And Requirements; Tool Identification - FAR RAC 185 Instrucciones De Uso

RAC 185 RAC 185
INSTRUCTIONS FOR USE
INDEX
GUARANTEE ............................................................................... 9

SAFETY MEASURES AND REQUIREMENTS ............................... 9

TOOL IDENTIFICATION ............................................................... 9

MAIN COMPONENTS ................................................................ 10
TECHNICAL DATA ..................................................................... 10
HOW TO USE YOUR RIVETING TOOL ....................................... 10
MAINTENANCE AND CHANGE OF SIZE
NAIL CONTAINER MANAGEMENT AND ADJUSTMENT ............. 12
DISPOSAL OF THE RIVETING TOOL ......................................... 12
GUARANTEE
FAR riveting tools are covered by a 12-month warranty. The
tool warranty period starts on the date of delivery to the
buyer, as specified in the relevant document. The warranty
covers the user/buyer provided that the tool is purchased
through an authorized dealer and only if it is used for the
purposes for which it was conceived. The warranty shall
not be valid if the tool is not used or maintained as specified
in the instruction and maintenance handbook. In the event
of defects or failures, FAR S.r.l. shall undertake solely to
repair and/or replace the components it judges to be faulty.
SAFETY MEASURES AND REQUIREMENTS
CAUTION!!!
All the operations must be done in conformity
with the safety requirements, in order to avoid
any consequence for your and other people's
security and to allow the best tool work way.
• Read the instructions carefully before using the tool.
• For all maintenance and/or repairs please contact
FAR s.r.l. authorized service centers and use only
original spare parts. FAR s.r.l. may not be held liable
for damages from defective parts caused by failure
to observe what above mentioned (EEC directive
85/374).
The list of the service centres is available on our website
http://www.far.bo.it ( Organization )
• The tool must be used only by expert workers.
• A protective visor and gloves must be put on when using
the tool.
• Use equipment recommended in the maintenance chapter
to do any maintenance and/or regulation of the tool.
• The tool can be carried and we suggest putting it into its box
after using.
Revisione - 00
I
................................ 11
GB
• The tool needs a thorough six-monthly overhaul.
• Repairing and cleaning operations must be done when the
tool is not fed.
• If it is possible, we suggest a safety balancer.
• If the A-weighted emission sound pressure level is more than
70 dB (A), you must use some hearing protections (anti-noise
headset, etc.).
• The workbench and the work surface must be always clean
and tidy. The untidy can cau se damages to people.
• Do not allow unauthorized persons to use the working tools.
• Make you sure that the compressed air feeding hoses have
the correct size to be used.
• Do not carry the connected tool by pulling the hose. The hole
must be far from any heating sources or from cutting parts.
• Keep the tools in good conditions; do not remove either safety
parts or silencers.
• After repairing and/or adjusting, make sure you have already
removed the adjusting spanners.
• Before disconnecting the compressed air hose from the tool
make sure that there is no pressure in the hose.
• These instructions must be carefully followed.
TOOL IDENTIFICATION
The riveting tool RAC 185 is identified from a marking that
shows company name and address of manufacturer, designation
of the tool, CE mark and year of manufacturing. If any service
is requested, please make reference to the data shown on
the marking.
Company name
and address
Date 11-2011
Designation of the tool
Year of manufacturing
9