Calibrate Ir Gas - Hach astroTOC UV/Turbo Analyzer Manual Básico Del Usuario

Figure 18 Remove the IR cell
1 IR bench assembly
2 Indentation for latch piston
3 Latch piston
4 Inspector lacquer
5 Power connector

Calibrate IR gas

Electrocution hazard. If relay contacts are connected to AC line voltage, remotely disconnect the power
before opening the upper enclosure door of the analyzer.
Potential Instrument Damage. Delicate internal electronic components can be damaged by static
electricity, resulting in degraded performance or eventual failure.
CO span gas at 1000 ppm or 10000 ppm is necessary to do this procedure.
2
6 Latch handle
7 Tie wrap
8 Inlet fitting and tubing
9 IR mirror assembly
10 Outlet fitting and tubing
D A N G E R
N O T I C E
English 35