Troubleshooting - EINHELL ETH 2000 Manual De Instrucciones

10. Troubleshooting

If the equipment is operated properly you should experience no problems with malfunctions or faults.
In the event of any malfunctions or faults, please check the following before you contact your customer
services.
Fault
Equipment does not
work
The equipment
does not heat
Anl_ETH_2000_SPK7.indb 13 Anl_ETH_2000_SPK7.indb 13
GB
Possible cause
Power plug is not connected
The topple cut-out has triggered
The thermostat control is set too low
Overheating guard has been triggered
The switch is set to blowing without
heating function.
- 13 -
Remedy
Connect the power plug
Place the machine on a level surface
Turn the thermostat control to the
right, to a higher temperature
Please note section 6.3
Set the heating function
17.02.2017 07:53:51 17.02.2017 07:53:51