1. Troubleshooting - EINHELL LHL 2000 A1 BL Manual De Instrucciones Original

11. Troubleshooting

If the equipment is operated properly you should experience no problems with malfunctions or faults.
In the event of any malfunctions or faults, please check the following before you contact your customer
services.
Fault
Equipment does not
work
The equipment does
not heat
Anl_2328232_LB5.indb 26 Anl_2328232_LB5.indb 26
GB/MT
Possible cause
- The power plug is not connected
- The topple cut-switch (Fig. 3/Item
5) is not pressed
- The thermostat control (Fig. 1/Item
3) is set too low
- The overheating guard has been
triggered
- The switch is set to blowing (Fig. 2/
Item B) without heating function
- 26 -
Remedy
- Connect the power plug
- Place the equipment on a level sur-
face
- Turn the thermostat control (Fig. 1/
Item 3) to a higher temperature
- Note section 7.4
- Adjust the heating function (Fig. 2/
Item C-D)
04.07.12 16:03 04.07.12 16:03