Replacing Nylon Line - McCulloch ELITE 3300/34cc Manual De Propietario

N. REPLACING NYLON LINE
1) Loosen the locking nut on the base of the
nylon head by turning it clockwise.
2) Remove the base cover assembly.
Remove the empty spool from the housing and
discard any remaining line.
REWINDING NEW LINE
3) Prepare 2 lengths (8ft each) of 2.4 mm nylon
line. Thread 1 end of each line into the two
holes on opposite sides of the spool. Pinch the
exposed ends flat with a pair of pliers to
prevent them slipping through the hole.
4) Wind the two lines in the same direction
around the spool.
FAULT FINDING TABLE
Check STOP switch is in the
position I.
Control fuel level min. 25%tank
capacity.
Check air filter is clean.
Remove spark plug, dry it, clean it
and adjust it, and replace it, if
necessary.
Change fuel filter. Contact your
dealer.
Carefully follow the cutting
accessory assembly instructions.
Check metal cutting accessory is
sharp. Otherwise, contact your
dealer.
Engine still gives trouble: contact your dealer.
REASSEMBLY
5) Slide the end of the two lines into the grooves
to hold the line temporarily.
6) Position the spool back into the housing and
pull the line through the eyelets.
7) Pull about 12cm (5ins) of line out on either
side.
8) Reassemble the nylon string head as
illustrated; mower gauge,spring and locking nut
(tighten in an anti-clockwise direction).
9) N.B: In order to extend the nylon line as it
wears down, pull the mower gauge
downwards and turn it in a clockwise direction
to feed out the desired length of line.
Engine will Engine runs badly
or looses power
not start
when cutting
•
•
•
•
The machine
runs but does
not cut well
•
•
•
•
A
•
•
11