Checking The Spark Plug; Technical Specifications; Exhaust Emissions; Standard Spare Parts - Stihl EVC 200 Manual De Instrucciones

Ocultar thumbs Ver también para EVC 200:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 29
● Return the STIHL gardening power tool
to its normal position and add fresh
engine oil. (
6.1)

7.4 Checking the spark plug

Recommended type: F7RTC
Avoid damage to the machine!
An unsuitable spark plug can result
in damage to the engine.
● Park the STIHL gardening power tool
on a flat surface, allow to cool and
remove the spark plug socket. Clean
the area around the spark plug.
● Unscrew spark plug (1) using a suitable
spark plug wrench.
● Check:
Check insulator (2) for damage and
cracks, check electrode (3) for deposits
and excessive wear. Always replace
spark plugs in doubtful condition.
Measure electrode gap A using a
suitable gauge and, if necessary,
carefully correct:
A = 0,7-0,8 mm
● Screw in the spark plug by hand as far
as it will go.
Then tighten the spark plug as follows
using a spark plug wrench so that
sealing washer (4) is compressed.
Used spark plug:
1/8 to 1/4 turn
New spark plug:
1/2 turn

8. Standard spare parts

Large air filter:
0004 124 1500
10
Small air filter:
0004 124 2800
Spark plug:
0004 400 7000
6

9. Technical specifications

9.1 Exhaust emissions

The CO
value measured in the EU type
2
approval procedure is specified at
www.stihl.com/co2 in the product-specific
technical data.
The measured CO
value was determined
2
on a representative engine in accordance
with a standardised test procedure under
laboratory conditions and does not
represent either an explicit or implied
guarantee of the performance of a specific
engine.
The applicable exhaust emission
requirements are fulfilled by the intended
usage and maintenance described in this
instruction manual. The type approval
expires if the engine is modified in any
way.
0478 983 9902 A - EN

Publicidad

Tabla de contenido
loading

Tabla de contenido