Attaching And Removing The Nozzle; Connecting To A Water Source; Connecting The High-Pressure Washer To The; Mains Water Supply - Stihl RE 80.0 Manual De Instrucciones

7 Connecting to a water source

6.5

Attaching and removing the nozzle

6.5.1 Attaching the Nozzle
2
► Push nozzle (1) onto the spray lance (2).
► Turn the nozzle (1) until it engages
► If the nozzle (1) cannot be pushed easily into the spray
lance (2): Grease the gasket on the nozzle (1) with grease
for fittings.
6.5.2 Removing the nozzle
2
► Press nozzle (1) and spray lance (2) together and turn
until stop.
► Pull nozzle (1) and spray lance (2) apart.
0458-001-8721-A
1
1
7 Connecting to a water source
7.1

Connecting the high-pressure washer to the

mains water supply

Connecting the water filter
If the high-pressure washer is operated with sandy water or
water from cisterns, a water filter must be connected to the
high-pressure washer. The water filter filters sand and dirt
out of the water and thus protects the components of the
high-pressure washer from damage.
Depending on the market, the water filter may be included
with the high-pressure washer.
► Unscrew the connector.
1
► Screw the water filter (1) onto the water supply and tighten
by hand.
Connecting the water hose
The water hose must meet the following requirements:
– The water hose has a diameter of 1/2".
– The water hose is between 10 m and 25 m long.
► Connect the water hose to a tap.
English
55