Preparing beverages
5.6
Preparing milk froth or warm milk
Prepare milk foam and warm milk on the Cappuccinatore.
The preparation of milk froth and warm milk is similar. Steam is required for
the preparation.
CAUTION
Hot water and hot steam owing out of the pipe
Do not reach into the steam that is owing out.
Do not touch the steam pipe during and immediately after use. Wait
until the steam pipe has cooled down.
Requirement: The appliance is ready for operation. The Cappuccinatore is
connected to the appliance and milk is connected.
1. Place a vessel beneath the Cappuccinatore.
2. Press the "Steam dispensing" button.
»
The ashing display indicates that the appliance is heating up for
steam dispensing.
»
The lit-up display than indicates that steam dispensing is ready.
3. Turn the selector switch of the Cappuccinatore until the desired setting
for milk foam or warm milk points upwards.
4. Turn the rotary regulator on the control panel clockwise up to the stop.
»
Beverage dispensing starts.
5. Turn the rotary regulator anti-clockwise up to the stop.
»
Beverage dispensing stops.
6. Remove the vessel.
7. Prepare further beverages or rinse the Cappuccinatore:
a) Prepare further beverages and rinse the Cappuccinatore later.
b) Rinse the Cappuccinatore as described below.
Information
After 30 seconds the appliance changes automatically from the steam
mode to the normal operating mode. Press the button for steam dispens-
ing, to change to the normal operating mode.
74