Twin Needle Stitch - Sears Kenmore 385.19233 Manual De Instrucciones

Twin needle stitch
Stitch Pattern:
Thread tension dial:
(_ Presser foot F:
(_ Twin needle
95
3to6
Satin stitch foot
NOTE:
• Do not set the stitch width at more than 3, otherwise
the needle may hit the needle plate or presser foot and
could possibly break.
• Turn off and unplug the machine before changing the
needle to the twin needle.
• Use #60 or finer threads for twin needle sewing.
This machine is equipped with a twin needle that can be
used to sew parallel rows straight on decorative stitches
adding an exquisite touch to table linens and clothing.
These stitch patterns (01 to 05, 8 to 10, 24, 27 to 30, 33 to
35, 37, 38, 43 to 47, 53, 55, 61 to 63, 65, 67, 70, 72 to 74,
77, 91, 94, and 95) (mode 2) can also be used.
Insert the additional spool pin, and put the felt and spool on
it with the thread coming off the spool as shown.
When threading the machine for twin needle sewing follow
these instructions making sure you separate the threads,
placing one in each thread guide on the needle bar.
• Starting to sew
Turn off and unplug the machine before changing the
needle to the twin needle. Insert the additional spool pin,
and put the felt and spool on it with the thread coming off
the spool as shown.
Press the twin needle button
When threading the machine for twin needle sewing
follow this chart making sure you separate the threads,
placing one in each thread guide on the sides of the
needle bar.
Threading from (_0to (_ is the same as for single thread.
Refer to page 32.
(_ Draw the threads down and slide them through the
lower thread guide.
(_ Slide the threads through the needle bar thread
guide one to each side.
Thread the needle from front to back.
At corners, raise the needles until they clear the fabric.
Partially raise the presser foot and carefully pivot the
fabric.
When twin needle sewing is completed, change needle
and reset tension (if necessary).
To return to single needle sewing, press the Twin
Needle button or turn off the power switch.
NOTE:
To avoid the thread twisting, it is advisable to thread the
machine one thread at a time.
S
01
I
+
3O
I
55
94
02 03
cl III
Ul
III
33 34
Ill 'l'
61 62
_ x x
95
04 05
35 37
III
111
63 65
08 09 10 24
38 43 44 45
67 70 72 73
27 28 29
46 47 53
74 77 91
®
/
J
92