Section V. Care Ofyour Machine; Assemble The Hook Race - Sears Kenmore 385.19233 Manual De Instrucciones

SECTION V. CARE OFYOUR MACHINE
Clean the hook race and feed dog
Screw driver
Set screw
(_) Needle plate
Lint brush
(_ Hook race
Bobbin holder
(_ Feed dog
(_ Soft, dry cloth
Press the up/down needle position button to raise the
needle, then unplug the sewing machine.
Do not dismantle the machine other than explained on this
page.
Remove the cover plate by sliding the cover plate release
button to the right. Take out the bobbin. Brush out dust and
lint. (You may also use a vacuum cleaner.)
Remove the set screw _ on the left hand side of the
needle plate _ with the screwdriver (_0supplied with the
machine. Remove the needle plate (_).
Take out the bobbin. Lift up the bobbin holder _ and
remove it.
Clean the hook with a lint brush.
Clean the feed dog and hook race with the lint brush.
Clean the center of the hook race with a dry cloth.
*You may also use a vacuum cleaner.
* The machine does not require oiling.
f
%
%
Assemble the hook race
Bobbin holder
Stopper
(_) Knob
(_) Needle plate guide pins
Screwdriver
Guide holes
Insert the bobbin holder so that the knob fits next to the
stopper in the hook race.
Insert the bobbin.
Attach the needle plate with screw.
After cleaning the machine, make sure the needle and
presser foot are attached.
%
%
J
106