Dust Extraction; Working With The Electric Power Tool - Festool DSC-AGC 18 FH Instrucciones De Uso Originales

8.2 Changing the diamond cutting disc [4]
WARNING
Risk of accident, risk of injury
► Only use the clamping nut provided. Do not
use quick-action clamping nuts.
► Only use diamond cutting discs that are
recommended by the manufacturer and
flanges that come supplied with the sand­
er.
► Do not use cutting discs that contain bind­
ers.
CAUTION
Risk of injury from hot and sharp tool
► Do not use any vibrating, blunt or defective
sanding tools.
► Do not use sanding tools that have been
exposed to extreme humidity, moisture or
high temperatures prior to installation.
► Wear protective gloves.
► Remove the battery pack from the power
tool.
► Place the flange [4-4] with the ridge on the
spindle.
► Ensure that the centring ridge of the flange
fits exactly into the opening in the disc and
that the form-fit connection between the
power tool/spindle and flange matches.
Ensure that the diameter of the power tool
spindle matches the hole in the sanding
tool.
Adhere to the stipulated rotational direction
of the sanding tool (arrow on the sanding
tool = arrow on the tool housing).
Place the diamond cutting disc [4-3] on the
spindle and flange.
► Position the clamping nut [4-2] on the dia­
mond cutting disc, press the spindle lock
and firmly tighten the clamping nut using
the face wrench [4-1].
► Check that the sanding tool is securely at­
tached and fitted to the power tool.
► Before switching on the power tool,
check to ensure that the cutting disc and
the moving part of the dust extraction at­
tachment [1-6] can move freely.
Let new discs run for around one minute
with no load as a test.
Removal is performed in reverse sequence to
assembly.
8.3 Plate [5]
The plate [5-1] reduces the risk of damaging
the workpiece surfaces.
► Slide the plate onto the front edge of the
dust extraction attachment's guide table
and lock into place.
8.4

Dust extraction

WARNING
Heath hazard posed by dust
► Always work with an extractor.
► Comply with national regulations.
A Festool mobile dust extractor with a suction
hose diameter of 27 mm or 36 mm (36 mm rec­
ommended due to the reduced risk of clogging)
can be connected to the extractor connec­
tor [1-1].
The adapter on a suction hose with a diameter
of 27 mm is inserted into the angle adapter .
The adapter on a suction hose with a diameter
of 36 mm is attached to the angle adapter .
Recommendation: Use an antistatic extractor
hose. This helps reduce the electric charge.
9 Working with the electric
power tool
WARNING
Risk of injury
► Only guide the power tool into the material
when it is switched on (running).
► Always secure the workpiece in such a
manner that it cannot move.
► Keep your hands away from the rotating
sanding tools.
WARNING
Risk of injury from the fragile sanding tool
► Ensure that the sanding tool's expiry date
has not been exceeded.
WARNING
Risk of injury due to moving workpiece
► Ensure that the workpiece is secure.
WARNING
Risk of injury from overhead work
► Always wear safety glasses for overhead
work.
► Wear a P2 respiratory mask.
English
23