Waste Disposal - Beninca CORE 230Vac Manual Del Usuario

ENg
The product shall not be used for purposes or in ways other than those for which the product
is intended for and as described in this manual. Incorrect uses can damage the product
and cause injuries and damages.
The company shall not be deemed responsible for the non-compliance with a good manu-
facture technique of gates as well as for any deformation, which might occur during use.
Keep this manual for further use.
This manual has been especially written to be use by qualified fitters.
Installation must be carried out by qualified personnel (professional installer, according to
EN 12635), in compliance with Good Practice and current code.
Make sure that the structure of the gate is suitable for automation.
The installer must supply all information on the automatic, manual and emergency operation
of the automatic system and supply the end user with instructions for use.
Packaging must be kept out of reach of children, as it can be hazardous. For disposal,
packaging must be divided the various types of waste (e.g. carton board, polystyrene) in
compliance with regulations in force.
Do not allow children to play with the fixed control devices of the product. Keep the remote
controls out of reach of children.
This product is not to be used by persons (including children) with reduced physical, sensory
or mental capacity, or who are unfamiliar with such equipment, unless under the supervision
of or following training by persons responsible for their safety.
Apply all safety devices (photocells, safety edges, etc.) required to keep the area free of
impact, crushing, dragging and shearing hazard. Bear in mind the standards and directives
in force, Good Practice criteria, intended use, the installation environment, the operating
logic of the system and forces generated by the automated system.
Installation must be carried out using safety devices and controls that meet standards EN
12978 and EN 12453.
An omnipolar switch/section switch with remote contact opening equal to, or higher than
3mm must be provided on the power supply mains.
Make sure that before wiring an adequate differential switch and an overcurrent protection
is provided.
Pursuant to safety regulations in force, some types of installation require that the gate
connection be earthed.
During installation, maintenance and repair, cut off power supply before accessing to live
parts.
Also disconnect buffer batteries, if any are connected.
The electrical installation and the operating logic must comply with the regulations in force.
The leads fed with different voltages must be physically separate, or they must be suitably
insulated with additional insulation of at least 1 mm.
The leads must be secured with an additional fixture near the terminals.
During installation, maintenance and repair, interrupt the power supply before opening the
lid to access the electrical parts
Check all the connections again before switching on the power.
The unused N.C. inputs must be bridged.

WASTE DISPOSAL

As indicated by the symbol shown, it is forbidden to dispose this product as normal urban
waste as some parts might be harmful for environment and human health, if they are dispo-
sed of incorrectly. Therefore, the device should be disposed in special collection platforms
or given back to the reseller if a new and similar device is purchased. An incorrect disposal
of the device will result in fines applied to the user, as provided for by regulations in force.
Descriptions and figures in this manual are not binding. While leaving the essential characteristics of
the product unchanged, the manufacturer reserves the right to modify the same under the technical,
design or commercial point of view without necessarily update this manual.
10
WARNINg