Tabla De Contenido; Warning Symbols; Safety Instructions - IKA MS 3 control Instrucciones De Manejo

Source language: German
Content
Page
Device setup/Display 2/3
Declaration of conformity 5
Warning symbols 5

Safety instructions

5
Unpack 6
Correct use 7
Commissioning 7
Declaration of conformity
We declare under our sole responsibility that this product corresponds to the re-
gulations 2014/35/EU, 2006/42/EC, 2014/30/EU and 2011/65/EU and conforms
with the standards or standardized documents EN 61010-1, -2-051, EN 61326-1,
EN 60529 and EN ISO 12100.

Warning symbols

Indicates an (extremely) hazardous situation, which, if
DANGER
not avoided, will result in death, serious injury.
Indicates a potentially hazardous situation, which, if not
WARNING
avoided, can result in death, serious injury.
Indicates a potentially hazardous situation, which, if not
CAUTION
avoided, can result in injury.
Indicates practices which, if not avoided, can result in
NOTICE
equipment damage.
Indicates crushing risk of fingers/hand.
CAUTION
EN
Accessories 9
Interface and output 10
Connection, laboratory device - PC 11
Error code 11
Maintenance 12
Technical data 12
Warranty 13
Safety instructions
For your protection
• Read the operating instructions in full before starting up and fol-
low the safety instructions.
• Keep the operating instructions in a place where they can be accessed by
everyone.
• Ensure that only trained staff work with the appliance.
• Follow the safety instructions, guidelines, occupational health and safety
and accident prevention regulations.
Wear your personal protective equipment in accor-
WARNING
dance with the hazard category of the medium to
be processed. Otherwise there is a risk of:
- splashing liquids
- projectile parts
- body parts, hair, clothing and jewellery getting caught.
• Keep hand/arm vibration to a minimum (Directive 2002/44/EC) when ope-
rated manually:
- Keep the sample container as vertical as possible.
- Only exert the minimum pressure necessary for the mixing process.
- Use attachments for multiple samples when there is a large number of
samples.
• Set up the appliance in a spacious area on an even, stable, clean, non-slip,
dry and fireproof surface.
• The feet of the appliance must be clean and undamaged.
Before starting the device set a low speed.
CAUTION
Gradually increase the speed.
• If the shaking movement of the appliance increases (resonance), reduce the
speed or pass through the critical phase as quickly as possible.
• Reduce the speed if
- the medium splashes out of the vessel because the speed is too high
- the appliance is not running smoothly
- the appliance begins to move around because of dynamic forces.
Caution! Risk of crushing when changing attach-
CAUTION
ments.
5