dirna Bergstrom bycool green line COMPACT ADR Instrucciones De Montaje página 24

COMPACT
EN
OUTSIDE CABIN:
5
Position Compact in sun hatch hole.
Caution! When positioning the unit above
the hatch gap, check that the wastewater
run-offs are not blocked by the EPDM
seal.
To place the foam rubber ducting remaining
6
at the softer part of the base.
INSIDE CABIN:
7
Screw about 5 mm (4) 8/125x100 or 120 mm
studs, the exact measure is chosen after the
fastening supports have been presented
and taking into account that studs must stick
out of lower part about 20 mm.
Following this order:
8
- Ø 7 plane rubber wash
- plane ruber wash wide wing diameter 8
- nut M8
- plane washer diameter 8 wide wing
6
Unit base
7
7
Ø 7 plane plane ruber
rubber wash wide
wash wing Ø 8
8
24
Air conditioning for vehicles
5 mm
Stud
Bracket
20 mm
plane washer
nut M8 Ø8 wide wing
5
Sun hatch
7