Starting Up Handytig 180 Dc Controlpro - LORCH HandyTIG 180 DC Basic Plus Manual De Instrucciones

Starting up HandyTIG 180 DC ControlPro

14 Starting up HandyTIG 180 DC ControlPro
15
Abb. 16: Control console Handy 180 DC ControlPro
9 Connector – torch control
TIG-torch control connector must be inserted
into this socket.
7-Segment-display
15
display the selected current.
Alternating display of code and set value by acti-
vated secondary parameters.
LED malfunction
16
lights up permanently, 7- segment-display
shows error code 15.
LED remote control
17
Hand remote connected:
LED lights up permanently, turning knob welding
current 27 without function, adjustment only pos-
sible at hand remote control.
Foot remote connected: LED lights up by activa-
tion, turning knob 27 displays the foot control's
maximum provided value setting. I.e. if 100A is
set, values of 5A-100A can be retrieved with the
foot remote.
LED HF
18
lights up if function HF is selected. (non-con-
tact ignition).
LED Pulsing
19
lights up if function pulsing is selected (pulsing
takes place between welding current I1 and I2).
LED Electrode
20
lights up if electrode mode is selected.
21 LED Slope
lights up if slope function is selected (slope,
down slope).
LED TIG
22
lights up if TIG mode is selected.
12.10
16 17 18
9 31 30 29 28
19 20 21 22 23
27 26 25
LED 2-stroke
23
lights up if 2-stroke mode is selected. (only with
TIG-welding procedure).
LED 4-stroke
24
lights up if 4-stroke mode is selected. (only with
TIG-welding procedure).
Key button for TIG/2-stroke/4-stroke mode
25
for the selection of TIG mode as well as 2-s-
toke and 4-stroke mode.
Key button for electrode/slope/pulsing mode
26
for the selection of electrode mode
as well as the mode Slope and Pulsing
To select the electrode mode, keep the key
pressed for at least 2 seconds.
Turning button for welding current adjustment
27
for the stepless setting of welding current.
LED Job 2
28
lights up if Job 2 is selected, flashes if settings
are saved/stored.
Key button Job 2
29
keep it pressed for at least 3 seconds, saves/
stores the present settings as job.
Quick press to retrieve saved job.
LED Job 1
30
lights up if Job 1 is selected, flashes after sav-
ing/ storing Job 1.
Key button Job 1
31
keep pressed for at least 3 seconds, saves/
stores the present settings as job.
Quick press to retrieve saved job.
24
- 33 -