Velleman VDPLW2300N Manual Del Usuario página 4

• Use the original packaging if the device is to be transported.
• All modifications of the device are forbidden for safety reasons.
• Only use the device for its intended purpose. All other uses may lead to short circuits, burns,
electroshocks, crash, etc. Using the device in an unauthorised way will void the warranty.
4. Features
• 8 individually controllable segments
• sound control or DMX mode
• DMX mode in 3/6/12/24/48 channels
• stand-alone or master/slave
• 25° beam angle
• smooth linear dimmer
• 8 built-in programs (DMX-triggerable)
• strobe effects in any colour
• 1 ~ 50 flashes per second
• LCD + jog wheel for easy menu control
5. Installation
a) Fuse
• Only fit or replace a fuse when the device is unplugged from the mains.
• Replace a blown fuse with a fuse of the same type and rating (see "Technical Specifications"):
1. Remove the fuse holder under the power socket at the back of the device.
2. Remove the old fuse and install a new one.
3. Replace the fuse holder.
b) Mounting the Device
• Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable
norms.
• The carrying construction must be able to support 10 times the weight of the device for 1 hour without
deforming.
• The installation must always be secured with a secondary attachment e.g. a safety cable.
• Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified
technician check the device once a year and once before you bring it into service.
• Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
• Overhead mounting requires extensive experience: calculating workload limits, determining the
installation material to be used... Have the material and the device itself checked regularly. Do not
attempt to install the device yourself if you lack these qualifications as improper installation may result
in injuries.
• Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
• Make sure there is no flammable material within a 0.5m radius of the device.
• Have a qualified electrician carry out the electric connection.
• Connect the device to the mains with the power plug. Do not connect it to a dimming pack.
• The installation has to be approved by an expert before the device is taken into service.
6. Operation
Initialization
Initialization starts as soon as you connect your VDPLW2300N to the mains. After the initialization, the
LCD will display "Addr
there is no DMX signal, the projector will preset a non DMX running mode: auto, sound or manual.
LCD Menu
Turn the jog wheel in a clockwise direction to display the following sequence:
Addr***, Manual blue***, Manual Green***, Manual Red***, No DMX/Sound/Manual, Chase 8
s***f_**,
Chase 8 s***f_**, Chase 7 s***f_**, Chase 7 s***f_**, Chase 6 s***f_**, Chase 6 s***f_**,
Chase 5 s***f_**,
Chase 5 s***f_**, Chase 4 s***f_**, Chase 4 s***f_**, Chase 3 s***f_**, Chase 3 s***f_**,
Chase 2 s***f_**,
Chase 2 s***f_**, Chase 1 s***f_**, Chase 1 s***f_**, DMX mode 8-group/4-group/2-group/1-
group, DMX mode 3channel/6channel.
09.11.2009
" when there is a DMX signal,
***
VDPLW2300N
indicating the present DMX address. When
***
4
©Velleman nv