Replacing The Prime/Spray Valve; Replacing The Filters - Titan IMPACT 400 Manual Del Propietário

replacing the PrImE/SPray Valve

Perform the following procedure using PRIME/SPRAY valve
replacement kit P/N 700-258.
1. Push the groove pin (1) out of the valve handle (2).
2. Remove the valve handle (2) and the cam base (3).
3. Using a wrench, loosen and remove the valve housing
assembly (4).
4. Make sure the gasket (5) is in place and thread the new valve
housing assembly into the pump block (6). Tighten securely
with wrench.
5. Place the cam base (3) over the valve housing assembly (4).
Lubricate the cam base with grease and line up the cam with
the pump block (6).
6. Line up the hole on the valve stem (7) with the hole in the
valve handle (2).
7. Insert the groove pin into the valve handle and through the
valve stem to secure the valve handle in position.
6
NOTE: when using "HOT" solvents, replace Viton o-ring
(item 8) with optional PTFE o-ring (700-897). Install
with o-ring tool (700-890).
English
5
4
3
7
1
8

replacing the Filters

Pump Filter
1. Loosen and remove the filter housing (1).
2. Turning clockwise, unscrew the filter (2) from the pump
manifold (3).
NOTE: Left-handed threads require turning the filter
clockwise to remove.
3. Make sure the filter seal (4) is in position.
4. Turning counterclockwise, screw the new or cleaned filter into
the pump manifold.
5. Slide the filter housing over the filter and thread it into the
pump manifold until secure.
3
1
2
Gun Filter
1. Move the gun trigger lock to the unlocked position.
2. Loosen and remove the handle (1) from the gun body (2).
3. Turning clockwise, unscrew the filter (3) from the gun body.
NOTE: Left-handed threads require turning the filter
clockwise to remove.
4. Turning counterclockwise, screw the new or cleaned filter into
the gun body.
5. Make sure the handle seal (4) is in position and thread the
handle into the gun body until secure.
6. Move the gun trigger lock to the locked position.
NOTE: For more detail, part number information, and
complete assembly drawings, please see the gun
owner's manual.
12
4
2
2
3
4
1
© Titan Tool Inc. All rights reserved.