Hitachi Koki WM 18DBL Instrucciones De Seguridad Y Manual De Instrucciones página 16

English
(2) Replacing the hook and tightening the screws.
Install securely the hook in the groove of power
tool and tighten the screws to fix the hook firmly.
(Fig. 9)
Hook
6. About Remaining Battery Indicator
When pressing the remaining battery indicator
switch, the remaining battery indicator lamp lights
and the battery remaining power can be checked.
(Fig. 10) When releasing your finger from the
remaining battery indicator switch, the remaining
battery indicator lamp goes off. The Table 6 shows
the state of remaining battery indicator lamp and
the battery remaining power.
Switch panel
Light switch
Remaining battery
indicator switch
Remaining battery
indicator lamp
State of lamp Battery Remaining Power
The battery remaining power
is enough.
The battery remaining power
is a half.
The battery remaining power
is nearly empty.
Re-charge the battery soonest
possible.
16
Groove
Screw
Fig. 9
Fig. 10
Table 6
As the remaining battery indicator shows
somewhat differently depending on ambient
temperature and battery characteristics, read it as
a reference.
NOTE:
Do not give a strong shock to the switch panel or
break it. It may lead to a trouble.
To save the battery power consumption, the
remaining battery indicator lamp lights while
pressing the remaining battery indicator switch.
7. How to use the LED light
Every time you press the light switch on the switch
panel, the LED light lights or goes off. (Fig. 11)
To prevent the battery power consumption, turn
off the LED light frequently.
Light switch
CAUTION
Do not expose directly your eyes to the light by
looking into the light.
If your eyes are continuously exposed to the light,
your eyes will be hurt.
NOTE:
To prevent the battery power consumption caused
by forgetting to turn off the LED light, the light goes
off automatically in about 15 minutes.
8. Tightening and loosening screws
Install the bit that matches the screw, line up the
bit in the grooves of the head of the screw, then
tighten it.
Push the tool just enough to keep the bit fitting
the head of the screw.
CAUTION
●
Applying the tool for too long tightens the screw
too much and can break it.
Tightening a screw with the tool at an angle to
that screw can damage the head of the screw and
the proper force will not be transmitted to the
screw.
Tighten with this tool lined up straight with the
screw.
Fig. 11