Prior To Initial Operation - SPARKY HeavyDuty BP 750CE Instrucciones De Uso

This power tool is equipped with a
mechanism for reducing vibrations, decreasing
them by more than 30%.

PRIOR TO INITIAL OPERATION

▪ Make sure the power supply voltage corre-
sponds to the value indicated on the name
plate with technical data of the tool.
▪ Always check the position of ON/OFF switch.
The power tool must be connected to the
power supply socket only when this switch is
in OFF position. If the plug is connected to
a receptacle while the power switch is in the
ON position, the power tool will start operat-
ing immediately, which could cause a serious
accident.
Application
Render / Light construction
materials
Chiselling tiles
Bricks
Drilling in concrete
Chiselling concrete
▪ Make sure that the cord and the plug are in
order. If the replacement of the supply cord is
necessary, this has to be done by the manu-
facturer or his agent in order to avoid a safety
hazard.
WARNING: Always switch off and un-
plug the power tool prior to any adjustment,
servicing or maintenance.
▪ In case the work area is remote from the pow-
er source, use as short as practicable exten-
sion cord with proper cross-section.
▪ Check that the auxiliary handle is properly
mounted and reliably tightened.
SWITCHING ON - SWITCHING Off
▪ Switching on: Push and hold down switch 7.
▪ Switching off: Release switch 7.
At low temperatures, demolishing with the pow-
er tool must begin only after it was operated for
about 3 minutes at no-load mode.
Original instructions
chine with 30% the red light-emitting diode 10
will glow. The machine must not be operated
conti nuously in this mode.
SELECTING THE SPEED, fREqUENCY
AND IMPACT ENERGY
Rotate the regulator 8 to choose a position
appropriate for the processed material. The
constant electronics maintain the speed, the
frequency and the impact energy constant, in-
dependently of the load, thus ensuring steady
operation mode. It is recommended to use the
operation modes listed in the table.
Regulator Rotation
position speed
A-B 120-145 min
C 175 min
D 200 min
E-f 225-250 min
G
Rotate the regulator 8 from position A to position
F to increase the speed, the frequency and the
impact energy. The indicator 9 shall blink with
green light.
To choose High Power mode, rotate the regula-
tor 8 to position G. This mode is specified by in-
creased impact energy up to 13 J. The indicator
9 shall glow with constant green light.
is recommen ded only when chiselling (ham-
mer mode), and for brief operation in impact
drilling mode. Continuous operation in impact
drilling mode shall result in operator's quick
fatigue and increased wear-out of the ma-
chine.
SELECTING THE OPERATION MODE
The switching of operation modes can be per-
formed when the machine is not operating.
This rotary hammer can be used in two opera-
tion modes:
WARNING: Upon overloading the ma-
Impact rate
1150-1450 min
-1 -1
1700 min
-1 -1
1950 min
-1 -1
-1
2800 min
-1
WARNING: Using High Power mode
Single impact
energy
4-5 J
7 J
8 J
9-10 J
13 J
7
EN