Bushnell TROPHY CAM HD 119874 Manual De Instrucciones página 25

USING THE SETUP MENU INPUT SCREENS
Camera Name Input
After selecting the Camera Name parameter (the only setting is "Input"), press OK.
If necessary, delete the previous or default name by pressing the RIGHT key until
the backspace symbol (
& "k") is highlighted, then keep pressing OK. Select (highlight) each alphanumeric
character you want, using the LEFT/RIGHT keys, and pressing OK after each one to
set it. When finished naming the camera, press MENU to save the name to memory.
Coordinate Input
After selecting the Coordinate Input parameter, press UP or DOWN to select the On
setting and press OK. The latitude and longitude for any location where you plan to
place the camera can be obtained at many websites, for example: http://itouchmap.
com/latlong.html. You can enter a nearby street address, just zip code, or use the
various types of maps to locate the approximate position. The format you will need
to use to enter the coordinates in the Trophy Cam HD Aggressor menu screen is
shown below:
Latitude
Longitude
Note: You may see "negative" latitude or longitude coordinates online. These
designate South latitudes and West longitudes. US/Canada locations will
have North (+) latitude coordinates and West (-) longitude coordinates.
) (located between letters "A" & "B", also between "j"
Degrees
Latitude
N=North,
(2 digits)
S=South
(La) N00,00'00"
(Lo) W000,00'00"
Degrees
W=West,
Longitude
E=East
(3 digits)
Minutes Seconds
Minutes Seconds
25