Lifted Hopper Lid Support Rod Installation; Using The High-Pressure Water Gun (*); Using The Camera Kit (Optional) - Nilfisk RS 850 Instrucciones De Uso

LIFTED HOPPER LID SUPPORT ROD INSTALLATION

Before working under the lifted hopper lid (44, Fig. G), it is necessary to install the support rod (17, Fig. F) according to the following
procedure.
Support rod installation
1. Remove the rod (17, Fig. F) from the housing and lift the lid as necessary, then install the rod in the housing (18).
Support rod removal
2. Perform the procedures described in step 1 in the reverse order.

USING THE HIGH-PRESSURE WATER GUN (*)

(*) Optional for some countries.
The machine is equipped with a high-pressure water system (optional) to be used for washing the machine or other purposes.
WARNING!
Do not run the high pressure pump when the water tanks are empty or low (the pump can be damaged).
The following procedure refers to the high-pressure water gun use.
1. Pick up the high-pressure water gun (9, Fig. E) inside the cab.
2. Withdraw part of the hose (21, Fig. F) and connect the gun (9, Fig. E) to the quick coupling (22, Fig. F).
3. Start the diesel engine at idle speed, as shown in the relevant paragraph.
4. Turn on the high-pressure pump with the lever (8, Fig. E).
5. If necessary, bleed the air from the system by turning the water gun knob completely counter-clockwise and by pressing the
water gun lever until the water comes out constantly and at low pressure.
Release the water gun lever and turn the knob clockwise to use the high pressure nozzle.
6. Run the engine at the desired speed.
7. Use the water gun by pressing the relevant trigger.
WARNING!
Protect body parts (eyes, hair, hands, etc.) properly, when performing cleaning procedures using compressed
air or water gun.
WARNING!
Do not run the high pressure pump for long periods without using the water gun.
8. After using the water gun, perform steps from 1 to 4 in the reverse order.

USING THE CAMERA KIT (optional)

1. To turn on the video system (1, Fig. AX) and the cameras (4 and 5), press the switch (2) when the ignition key (24, Fig. D) is
inserted.
2. When the reverse gear is engaged, the video system and cameras turn on automatically.
3. For the functions of other switches on the right side of the display, refer to the camera kit Manual.
INSTRUCTIONS FOR USE
RS 850 33015123(3)2008-02
ENGLISH
25