Winter Maintenance; Safety Functions - Nilfisk RS 850 Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ENGLISH

WINTER MAINTENANCE

In winter, perform the following maintenance procedures carefully.
Procedures for machine storage or for machines working at less than +32°F (0°C)
1.
Drain the nozzles and water tanks.
2.
Drain and clean/replace the water fi lter.
3.
Pour antifreeze in the water tanks (check the quantity).
4.
Turn on the water pump (see the procedure in the relevant paragraphs) to let the antifreeze fl ow through the system until
it comes out from the broom nozzles, from the suction hose nozzle and from the rear pipe nozzle (if equipped). When the
antifreeze comes out from the nozzles, stop the pump.
5.
Start the diesel engine as shown in the relevant paragraph.
6.
Turn on the high-pressure washing system pump (see the procedure in the relevant paragraphs) and let the antifreeze fl ow
through the high-pressure washing system until it comes out of the water gun. When the antifreeze comes out, stop the pump.
WARNING!
Do not use the dust control system when the outside temperature is lower than +32°F (0°C) because it can
create ice sheets on the pavement.
Procedures to perform when the machine has been stored for two months
7.
Replace the engine oil and oil fi lter (see the relevant paragraphs).
8.
Fill the fuel tank (see the relevant paragraph).
9.
Apply grease.
10.
Charge the battery.
11.
Check the wheel pressure (see the relevant paragraph).
Procedures to perform when the machine has been stored for three months
8.
Perform the same procedures of the second month.
9.
Each month connect a battery charger and keep the battery charged for 12/24 hours.

SAFETY FUNCTIONS

The machine is equipped with the following safety functions.
Reverse gear buzzer
The machine is equipped with a sensor and a buzzer to indicate that the machine is moving in reverse.
Broom speed limiter
The machine is calibrated to stop broom rotation when the engine speed is above 2,050 rpm.
Joystick safety push-button
The push-buttons on the joystick are active only if the safety push-button (on the joystick) is pressed.
Safety device for control sequence during broom start-up
The suction inlet lowers only when the broom switch is pressed; the broom rotation starts only when the suction inlet is completely
lowered.
Sensor for engine start-up inhibition when the drive pedal is pressed
The machine is equipped with a sensor that do not allow for engine start up when the drive pedal is pressed.
42
INSTRUCTIONS FOR USE
33015123(3)2008-02
RS 850

Publicidad

Tabla de contenido
loading

Tabla de contenido