Configuring The System Settings (Advanced Setup Menu); Advanced Setup Menu Items; Changing The Fm/Am Tuning Frequency Setting (Tuner); Restoring The Default Settings (Init) - Yamaha R-N301 Manual De Instrucciones

Configuring the system settings (ADVANCED SETUP menu)

Configure the system settings of the unit while viewing the front display.
1
Turn off the unit.
2
While holding down RETURN on the front
panel, press A (power).
A (power)
STANDBY/ON
DISPLAY FM MODE MEMORY
BASS
PHONES SPEAKERS
A B
3
Rotate SELECT/ENTER to select an item.
4
Press SELECT/ENTER to select a setting.
5
Press A (power) to set the unit to turn off and
turn it on again.
The new settings take effect.

ADVANCED SETUP menu items

Item
Changes the FM/AM tuning frequency
TUNER
setting.
Restores the default settings.
INIT
Updates the firmware.
UPDATE
Checks the version of firmware
VERSION
currently installed on the unit.
Changing the FM/AM tuning
frequency setting (TUNER)
TUNER•••FM50/AM9
Change the FM/AM tuning frequency setting of the unit
depending on your country or region.
Settings
Select this when you want to adjust the FM frequency
FM100/
by 100-kHz steps and AM by 10-kHz steps.
AM10
Select this when you want to adjust the FM
FM50/AM9
frequency by 50-kHz steps and AM by 9-kHz steps.
(default)
36
En
RETURN
FM/AM PRESET TUNING
VOLUME
SELECT
TREBLE INPUT PUSH - ENTER
RETURN
SELECT/ENTER
Function Page

Restoring the default settings (INIT)

INIT••••••CANCEL
Restores the default settings for the unit.
Choices
Restores the default settings for the unit.
ALL
Does not perform an initialization.
CANCEL

Updating the firmware (UPDATE)

UPDATE•••NETWORK
New firmware that provides additional features or product
improvements will be released as needed. If the unit is
connected to the Internet, you can download the firmware
via the network. For details, refer to the information
supplied with updates.
■ Firmware update procedure
Do not perform this procedure unless firmware update is
necessary. Also, make sure you read the information
supplied with updates before updating the firmware.
1
36
When the "NETWORK" displayed on the front
display, press RETURN to start firmware
36
update.
36
y
If the unit detects newer firmware over the network,
36
"NewFwAvailable" appears as the "Information" menu item in
"Network Setup". In this case, you can also update the unit's
firmware by following the procedure in "Updating the unit's
firmware via the network" (p.37).
Checking the firmware version
(VERSION)
VERSION••••xx.xx
Check the version of firmware currently installed on the unit.
y
• You can also check the firmware version in "Update" (p.35) in
the "Setup" menu.
• It may take a while until the firmware version is displayed.