Assembling Magicwatch; Tools Required - Waeco MagicWatch MW150 Instrucciones De Montaje Y De Uso

MW-150.book Seite 27 Freitag, 6. Januar 2006 11:21 11
MagicWatch MW150
7

Assembling MagicWatch

7.1

Tools required

The following tools are needed for installation:
set of bits
electric drill
screwdrivers
set of spanners
The following tools are needed for making the electrical connections:
diode test lamp or voltmeter
insulating tape
maybe rubber bushings
Depending on individual circumstances, you may also need other screws,
bolts, nuts, washers, metal screws and cable connectors.
7.2 Assembling Sensors
To assure a proper operation it is important to fix the sensors with
the correct inclination.
Are the sensors turned to the ground, it indicates the surface of
the ground like an obstacle. Are the sensors turned to high,
obstacles may not be detected.
Consider the following specifications when assembling:
The maximum detection distance is approx. 1.2 m.
To protect the edges of the vehicle (indication lights) please mount the
sensors within 0.3 m from the edge.
The sensors should be mounted aprox. 40 – 50 cm away from the bottom
(see fig. 9, page 5).
The horizontal alignment of the sensors should be 0° from the centerline
(see fig. 9, page 5).
Assembling MagicWatch
27