Possible Troubleshooting - EdilKamin LOGO Instalación Uso Y Mantenimiento

POSSIBLE TROUBLESHOOTING

1)
ir ow ma be insuf cient because the door is open, the door does not close properl (e.g. bad seal), there is an
air intake or smoke e traction problem, or the combustion chamber is clogged.
heck
door closure;
combustion air intake duct (clean, pa ing attention to the ow sensor components);
clean the ow sensor with dr air (like that used for
stove location it must not be installed against a wall;
combustion chamber position and cleanliness (clean regularl according to the t pe of pellet);
smoke duct (clean);
installation (if it does not compl with regulations or the smoke outlet has more than - bends);
f ou suspect the sensor is malfunctioning, carr out cold tests. f the conditions are changed (for e ample b
opening the door) and the value does not change, there is a sensor problem.
he no depression alarm ma also occur during ignition, since the ow sensor starts monitoring 9 seconds after
the ignition c cle begins.
heck smoke e tractor function (devolution sensor connection) and board ( E LER).
heck smoke channel for dirt
erif the electrical s stem and earthing s stem.
heck eletronic circuit board ( E LER).
interprets as the absence of ames)
urns off due to drop in smoke temperature
lack of pellets
too man pellets have suffocated the ame, check pellet qualit ( E LER)
the ma imum thermostat has intervened (rare, this onl intervenes in the event of e cessive smoke
temperature) ( E LER)
temperature is not reached).
istinguish either of the following cases
heck - combustion chamber position and cleanliness;
arrival of combustion air in the combustion chamber;
if the heating element is working ( E LER);
room temperature (if lower than
r to light with a relighter (see page 9).
heck (onl b the ealer)
if the thermocouple is working ( E LER);
start-up temperature setting in the parameters ( E LER).
Repeat start up after having empt ing the bra ier.
heck electricit connection and drops in voltage.
heck connection of thermo coupling to board check function in cold test ( E LER).
(intervenes if the ow sensor detects insuf cient combustion ).
(this trips if the smoke e traction speed sensor detects a fault)
(this trips if the thermocouple detects a smoke temperature lower than the value set, which it
(intervenes if a ame fails to appear within a ma imum of
use a relighter) and damp.
(not a defect of the stove).
(intervenes if the thermo coupling has failed or is disconnected).
ke boards);
- 35
-
minutes, or if ignition