Turn On/Off The Unit; Mute; Faceplate Release; Sound Adjustment - Blaupunkt MADRID 170 BT Manual De Uso

OPERATION

TURN ON/OFF THE UNIT

Turn on the unit by pressing
When system is on. Press and hold
button (4) for 2 seconds to turn off the unit.

MUTE

Shortly press MUTE
the audio output. Press it again to recover
output.

FACEPLATE RELEASE

Press release button
removable faceplate.

SOUND ADJUSTMENT

Press MENU button (4) shortly to select the
desired adjustment mode. The adjustment
mode will change in the following order:
-BASS-TRE-BAL-FAD-EQ-XBASS-BEEP-
DX-STEREO-CLOCK-AREA
TRE: treble
BAL: balance
FAD: fader
EQ: equalization
DX:
distance
By rotating the audio knob (19) it is possible
to adjust the desired sound quality or
setting.
Press and hold MENU button (4) for 2 seconds
into the RDS menu as below:
AF-TA-TA VOL-REG
AF: Alternative Frequencies
TA: Traffic Announcement
TA VOL：TA volume
EQ (Equalisation)
Press it shortly to select the preset EQ
mode as below:
CLASSICS—ROCK—POP—FLAT—EQ OFF
XBASS
Press and hold the EQ button for 2 seconds
button(4).
button(1) to muting
(5) to detach the
to active the XBASS function. Press and
hold it again to cancel this function.
BEEP on/off:
The car audio device is equipped with 2
beep tone modes. Rotate the volume
knob to choose one.
- Beep on mode: The confirmation beep
sound is heard whenever a button is
pressed.
- Beep off mode: The confirmation
beep is switched off whenever a key
is pressed.
LOC/DX:
In this item rotating the audio knob (6)
to turn on/off local function. In LOC mode
the unit will reduce the receiving
sensitivity when you search station.
That means you can receive the station
that sound is good. It will ignores the
station that sound is not good. In DX
mode it will increase the receiving
sensitivity when you search the station.
That means you can receive more
stations.
STEREO/MONO: In this item rotating the
audio knob (6) to choose STEREO or MONO
mode. In STEREO mode you can receive FM
stereo signal. In MONO mode the stereo
station will be switched to monochrome.
Sometimes when the signal is not good. If
you change it to MONO mode. The noise
will be reduced.
CLOCK
In the CLOCK item of the SEL menu. There are
12 HOUR and 24 HOUR format for your
choose.
Note: If you select the EUR(USA or LAT) region
in AREA item. The clock will become to 24(12)
HOUR format automatically. If you want to use
185
E
N
G
L
I
S
H