Maintenance; General Inspection; Warranty - SPARKY Sparkeye FSPE 85 Instrucciones De Uso

sure that it is not directed towards the eye of a person.
Always ensure the laser beam is aimed at a sturdy work
piece without reflective surfaces i.e. wood or rough coat-
ed surfaces are acceptable.
Bright shiny reflective sheet steel or the like is not suit-
able for laser use as the reflective surface could direct
the beam back at the operator. Only turn laser beam on
when tool is on work piece.
1. Mark the line of the cut on the work piece.
2. Adjust the bevel angle of cut as required.
3. Plug in the machine and start the motor.
4. When the blade is at its maximum speed (approxi-
mately 2 seconds), place the saw on the work piece.
5. Switch on the laser beam using the switch (2).
6. Align the beam with the mark on the work piece and
slowly push the saw forward using both hands, keep-
ing the red light beam on the mark.
7. Switch off the laser beam on completion of the cut.
The laser light is powered from a transformer housed
within the assembly (1). The SPARKEYE® laser line can
be used for improved operator cutting vision, accuracy
of cut, faster set-up and increased safety of operation.
The laser beam can be switched on and off using the
switch (2).
VIII - Maintenance
WArning: Always ensure that the tool is
switched off and the plug is removed from the power
point before making any adjustments or maintenance
procedures.
cleAning
▪ Keep the tool's air vents unclogged and clean at all
times.
▪ Remove dust and dirt regularly. Cleaning is best done
with a rag.
▪ Re-lubricate all moving parts at regular intervals.
▪ Never use caustic agents to clean plastic parts.
WArning: Do not use cleaning agents to
clean the plastic parts of the tool. A mild detergent on a
damp cloth is recommended. Water must never come
into contact with the tool.

generAl inspection

Regularly check that all the fixing screws are tight. They
may vibrate loose over time.
poWer corD mAintenAnce
Make sure that the cord and the plug are in order.If the
replacement of the supply cord is necessary, this has
to be done by the manufacturer or his agent in order to
avoid a safety hazard.
8
en
IX - Warranty
The guarantee period for SPARKY power tools is deter-
mined in the guarantee card.
Faults due to normal wear, overloading or improper han-
dling will be excluded from the guarantee.
Faults due to defective materials implemented as well as
defects in workmanship will be corrected free of charge
through replacement or repair.
The complaints for defective SPARKY power tools will
be recognized if the machine is sent back to the dealer
or is presented to the authorised warranty service centre
undismantled, in its initial condition.
Notes
Carefully read the entire original instructions before us-
ing this product.
The manufacturer reserves the right to make changes
and improvements to the products and to alter specifica-
tions without prior notice.
Specifications may differ from country to country
FSPE 85