Dirna Bycool FLAT Instrucciones De Montaje página 20

dirna
FLAT , s.a.
EN
ES
Detailed instructions on the installation
of power supply cables
1- Take the power cable of the equipment through to the vehicle battery and secure with flanges; use the same
passage as the original cabling. When the equipment is connected to the battery, this will carry out a test of all
the LEDs and will then go off.
IMPORTANT: Due to the complex system of electronic regulation of the equipment, the cu-
rrent connection must be made directly to the vehicle battery and not to any other point which
services other accessories of the vehicle, taking the precaution to not invert the polarity when
making the connection (2). Inverting the polarity may result in irreparable damage to the elec-
tronics, which is not covered by the warranty.
IMPORTANT: Check the User Manual before starting up.
2 2
+
-
20