Transportation And Storage; Troubleshooting - GreenWorks CSG301 Manual Del Operador

Ocultar thumbs Ver también para CSG301:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Make sure that it is turned over periodically to keep
symmetrical wear on the bar.
1. Lubricate the bearings on the nose sprocket (if present)
with the syringe (not included).
2. Clean the bar groove with the scraping hook (not
included).
3. Clean the lubrication holes.
4. Remove burr from the edges and level the cutters with a
flat file.
Replace the bar if:
the groove does not fit with the height of the drive links
(which must never touch the bottom).
the inside of the guide bar is worn and makes the chain
lean to one side.
12
TRANSPORTATION AND
STORAGE
Before you move the machine, always
Remove the battery pack from the machine.
Keep hands clear of the lock-out button.
Put the scabbard on the guide bar and the chain.
Before you put the machine into storage, always
Remove all residual oil from the machine.
Remove the battery pack from the machine.
Clean all unwanted material from the machine.
Make sure that the storage area is
Not available to children.
Away from agents which can cause corrosion, such as
garden chemicals and de-icing salts.
NOTE
English
13

TROUBLESHOOTING

Problem
The guide bar and
the chain become
hot and release
smoke.
The motor runs
but the chain does
not rotate.
13
Possible cause
Solution
The chain is too
Adjust the chain
tight.
tension.
The oil tank is
Add oil.
empty.
Contamination
Remove the guide
causes a blockage
bar and clean the
of the discharge
discharge port.
port.
Contamination
Clean the oil tank.
causes a blockage
Add new oil.
of the oil tank.
Contamination
Clean the guide
causes a blockage
bar and the oil
of the guide bar
tank cap.
and the oil tank
cap.
Contamination
Clean the sprocket
causes a blockage
and the guide
of the sprocket or
wheels.
guide wheels.
The chain is too
Adjust the chain
tight.
tension.
The guide bar and
Replace the guide
the chain are dam-
bar and the chain
aged.
if it is necessary.
1. Remove the
battery pack
from the ma-
chine.
2. Remove the
guide bar cov-
er.
3. Remove the
bar and saw
chain.
The motor is dam-
4. Clean the ma-
aged.
chine.
5. Install battery
pack and oper-
ate the ma-
chine.
If the sprocket ro-
tates, it means the
motor works prop-
erly. If not, call
service center.
EN

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

20362

Tabla de contenido