List Of Appropriate Drives - RK Rose+Krieger MultiControl duo Instrucciones De Montaje

7.9 List of appropriate drives

There is a list of drives which can be connected to the controller in the table below.
Indication
01 not used
10 Multilift
20 Slimlift
30 LZ 60
35 LZ drive unit
40 Powerlift
41 Powerlift med.
Powerlift
42
43 Telescopic Powerlift
60 AlphaColone (qkt...)
61 AlphaColone (qlt...)
81 Lambda Colone
91 Special applications (to order)
99 Special applications (to order)
7.9.1 How do I detect the set drive?
The controller is set in the factory to a given drive type.
The drive type is recorded on the data medium (see picture).
The data medium is stuck to every controller.
In this example, the controller is registered on the "Slimlift"
drive (Code: 20).
If you connect the controller to the mains, the drive set in the
controller appears briefly in hand switches with display (e.g.
"20").
7.9.2 How do I recognise the software
release?
The configuration plate shows the software (SW) and hard-
ware (HW) releases as well as the drive type.
If you connect the controller to the mains, the software ver-
sion programmed in the controller appears briefly in hand
switches with display (e.g. "2.17").
Drive
spindle
7. Working life
73