Connecting The Hand Switch - RK Rose+Krieger MultiControl duo Instrucciones De Montaje

7.3.2 Connecting the hand switch

You can connect the following hand switches to the controller:
RK MultiControl duo
paralleler
serieller
Handschalter Handschalter
parallel handset serial handset
•
Plug the lead from the 2-key hand switch into the parallel socket 7 (see section 7.2.2 or 7.2.3).
•
Plug the lead from the 6-key hand switch or the base station for the 8-key wireless hand swit-
ch into the serial socket 6 (see section 7.2.2 or 7.2.3).
You can connect a serial and a parallel hand switch simultaneously. In this case, the serial hand
switch has priority, i.e. the parallel hand switch is not in operation. If you want to use the parallel
hand switch, pull the controller mains plug out of the socket. Remove the serial hand switch. Af-
ter a pause of at least 30 seconds, replace the mains plug in the socket. You can now move the
drives with the parallel hand switch.
6-key hand switch
F
III
Antrieb 2
Antrieb 1
drive 2
drive 1
I II
serial hand switch
7. Working life
wireless hand switch with base station
RK EASYLIFT
F
1
2 3
4 5
2-key hand switch
parallel
hand switch
RK-0021
57