Intended Use; Operation; Initial Operation; Switch On/Off - Festool CT 26 E HEPA Manual De Instrucciones Original

[1-8]
Switch
[1-9] Locking clip
[1-10] Dust container
[1-12]
Brake

6 Intended use

The dust extractor is designed for use as speci­
fied for the aspiration and evacuation of non-
noxious dusts, dirt, sand, shavings etc..
The dust extractor is designed as specified for
vacuuming water.
The dust extractor is designed for household,
commercial or both use.
The dust extractor is designed for outdoor use
and indoor storage.
The filtering performance of the overall unit,
which is fitted with a HEPA filter element, cor­
responds to HEPA quality 13 (medium degree of
filtration 99.95%).
All CT extractors fitted with the HEPA filter ele­
ment have HEPA certification both for the filter
material and the whole dust extractor.
WARNING
The user will be liable for damage due to im­
proper use.

7 Operation

WARNING
Unauthorised voltage or frequency!
Risk of accident
► The mains voltage and the frequency of the
power source must correspond with the
specifications on the machine's name
plate.
► In North America, only Festool machines
with the voltage specifications 120 V/60 Hz
may be used.
Consider the pictures on the fold-out page.
7.1

Initial operation

► Open the locking clips [2-2] and remove the
top section of the machine [2-1].
► Remove the accessories from the dust con­
tainer [2-3] and the packaging!
► Insert a filter bag in the dust container (see
chapter " 10.1 ").
► Attach the cable holder to the rear of the
mobile dust extractor (see Fig. [3]).
3
► Replace the top section [2-1] and close the
locking clips [2-2].
► Connect the suction hose to the machine.
7.2

Switch on/off

► Insert the plug into an earthed socket.
CAUTION
Risk of injury from tools starting up unex­
pectedly
► Before setting the switch to the "AUTO" or
"MAN" position, make sure that the con­
nected tool is switched off.
The switch [1-8] serves as an On/Off switch. It
has three positions:
Switch position "0"
Appliance socket [1-3] is disconnected from the
power, mobile dust extractor is switched off.
"MAN" switch position
Appliance socket [1-3] is disconnected from the
power, the mobile dust extractor starts.
"Auto" switch position
Appliance socket [1-3] is connected to the pow­
er, the mobile dust extractor starts when the
connected tool is switched on.
English
9