Tabla de contenido
Publicidad
8
8
8
118
5-55
5-56
5-57
5-58
Operation
Figure 5-55 OPTIMISATION "6"
(second measuring run with tyre)
Rotate the wheel into marking position following the
arrows.
In this position mark the tyre, on the outer side of
the wheel, precisely above the chuck.
Confirm by pressing key 8.
The OPTIMISATION "7" screen may be displayed
(Fig. 5-57).
Alternately the indication H1 may appear
If H1 is displayed (Fig. 5-56), further optimisation is not
recommended since the measurement values which
activate the optimisation recommendation are below
the pre-set limit value.
However, it is possible to continue optimisation so as
to improve wheel silent running conditions even below
the limit value (critical vehicle).
To continue optimisation:
Continue as shown on screen OPTIMISATION OP
"7" (Fig. 5-57).
To abort optimisation
To abort optimisation, press the STOP key, return
to the balancing program and balance the wheel
according to the instructions displayed
Figure 5-57 OPTIMISATION "7"
On the tyre changer, turn the tyre with respect to
the rim until the valve is aligned with the mark made
on the tyre.
Confirm by pressing key 8.
The OPTIMISATION "8" screen appears (Fig. 5-58).
Figure 5-58 OPTIMISATION "8"
(third measuring run with tyre)
Clamp the wheel.
Rotate the wheel until the valve is exactly
perpendicular to and above the chuck.
Confirm the valve position by pressing key 8.
5.9.
Publicidad
Tabla de contenido
