System Messages - Hofmann geodyna 7850P Manual De Operador

146
7-1
7-2
Trouble shooting
7.1

System messages

The wheel balancer can show
operator. These may be error related (E-codes) (e.g. E
2 - Figure 7-1), warnings (H-codes) (e.g. H33 - Figure
7-2) or Hardware problems (X-Codes). The codes will
be described in the following chapters.
Whenever a code appears:
• make a note of it;
• look up the code in the list.
• perform the steps described.
Important:
If the code is not listed here, call service team.
Errors in operation
Warnings
Fatal error code
7.1.1 E-Codes
E1
Rim dimensions were entered incorrectly, or
incompletely.
 When the error code is read out, enter data once
again.
E2
Wheel guard is not closed.
E3
Geodata gauge arm for distance and rim diameter is
not in home position.
E4
Geodata width gauge arm is not in home position.
E5
Range of electrical compensation exceeded
(wheel adaptor has unacceptable unbalance).
 Press STOP or ESC–key.
 Check wheel adaptor, repeat compensation run.
E6
The calibration weight was not fitted for readjustment.
 Press STOP or ESC–key.
 Repeat readjustment.
E7
With this wheel type it is not possible to choose a
balancing mode.
 If necessary, choose another wheel type.
messages to the
- Error code E
- Error code H
- 300 or C10