Tabla de contenido
Publicidad
180
ii-1
ii-2
Installation
ii Transportation, unpacking and contents
Transportation
The wheel balancer is supplied on a pallet.
• Use a pallet truck (Figure ii-1) to bring the wheel
balancer to its working area.
Unpacking
WARNING: PREVENT THE STRAPS FROM
SPRINGING LOOSE AFTER BEING CUT.
•
Cut the straps.
•
Open the top of the box.
•
Remove staples at the bottom of the box. Lift the
box up and over the unit.
•
Carefully unwrap the balancer and spare parts
supplied.
•
Check the contents of the shipment.
Contents
The shipment contains:
-
a wheel balancer.
-
an Operator's Manual with Declaration of Conformity
(CE).
-
the accessories mentioned in Section 3.1 of the
Operator's Manual.
-
3 storage hooks and flanges.
-
a mains power cable.
-
a wheel guard assembly (if present).
Tools required
-
screwdriver / bar (diameter 4.5-5 mm)
-
keys:
13,
17 mm
-
Allen wrench:
5
mm
Positioning
•
Remove the bolts that secure the wheel balancer
on the pallet.
CAUTION: DO NOT LIFT OR MOVE THE
WHEEL BALANCER BY THE MAIN SHAFT OR
MEASURING
UNIT.
•
Refer to Figure ii-2. Move the wheel balancer from
the pallet to its working location.
Note: Use the storage hooks (mount as
instructed in
section
iii) and/or the wheel guard shaft
(if present) to handle the wheel balancer.
Publicidad
Tabla de contenido
