Maintenance And Cleaning - FALMEC FENICE2481 Manual De Instrucciones

I
LIGHTING
1. SPOTLIGHT
How to replace a square halogen light:
a) Check that the equipment is disconnected from the power supply.
b) Open the panel completely till 90° (see figure) pressing the PUSH button
c) Replace the lamp with a similar one (halogen, max 20 W, 12 Volt, G4 connection).
d) Close the panel. If the panel does not close correctly repeat the operation at point b.
2. GLASS LIGHTING
To replace the incandescent lamp:
1) ensure the hood is disconnected from the electric mains;
2) remove the decorative glass (see sec. O);
3) replace the lamp with one of the same model (max. 25W);
4) re-mount the glass (see fig. O5).
3. MIRABILIA LED LIGHTING
The hood is equipped with high efficiency, low power consumption LED lighting (light on
the work top and decorative light on the glass panes), with high durability under normal
use conditions.
WARNING: Do not remove the glass if the glass LED lighting is on.
L

MAINTENANCE AND CLEANING

Constant maintenance ensures the correct operation and efficiency of the appliance over
time. Special attention should be paid to the metal grease-trapping filters and the charcoal
filters. Frequent cleaning of the filters and their supports will ensure that fats and grease do
not accumulate on the range hood, with the consequent risk of fire.
1. METAL GREASE-TRAPPING FILTERS
These trap the fat and grease particles suspended in the air, and therefore should be
washed every month in hot water and detergent, without bending them. Wait until they
18
ASSEMBLY AND REPLACEMENT