AGS IsoMatic 500 Instrucciones De Montaje página 10

ENGLISH
2.5 Safety instructions for fitting
The specialist carrying out the work must ensure that
installation is conducted in compliance with the prevailing
national job safety rules and regulations and those governing
the operation of electrical equipment. In the process, the
relevant national guidelines must be observed. Potential
hazards as outlined in EN 13241-1 are avoided by
construction and fitting according to our guidelines.
The garage ceiling must guarantee secure fastening of the
operator. For ceilings which are too high or too light, the
operator must be fastened with additional struts.
Risk of deadly electric shock from
mains voltage
See warning in section 3
▶
WARNING
Unsuitable fixing material
▶ See warning in section 3
Danger of injury due to unwanted door travel
See warning in section 3
▶
Crushing hazard during boom fitting!
See warning in section 3
▶
2.6 Safety instructions for initial start-up
and for operation
Danger of injury during door travel
If people or objects are in the area
around the door while the door is
in motion, this can lead to injuries
or damage.
▶ Make sure that children are not
playing near the door system.
Make sure that no persons or
▶
objects are in the door's area
of travel.
If the door system has only one
▶
safety feature, only operate the
garage door operator if you are
within sight of the door's area
of travel.
Monitor the door travel until the
▶
door has reached the end-of-travel
position.
Only drive or pass through remote-
▶
control door systems when the door
is at a standstill!
▶ Never stay standing under the
open door.
WARNING
Danger of injury due to a fast-closing door
See warning in section 8.2.1
▶
10
DANGER
CAUTION
WARNING
Danger of crushing in the boom
Do not reach into the boom with your fingers during door
travel, as this can cause crushing.
Do not reach into the boom during door travel.
▶
Danger of injury from the cord knob
If you hang on the cord knob, you may fall and injure
yourself. The operator could break away and injure persons
or damage objects that are located underneath.
The operator could be destroyed.
Do not hang on the cord knob with your body weight.
▶
Danger of injuries due to the hot lamp
Touching the lamp during or immediately following operation
can lead to burns.
Do not touch the lamp if it is switched on or was
▶
recently switched on.
ATTENTION
If external voltage is applied, it will destroy
the electronics.
External voltage on the connecting terminals of the control
will destroy the electronics.
Do not apply any mains voltage (230 / 240 V AC) to the
▶
connecting terminals of the control.
2.7 Safety instructions for using the hand
transmitter
Danger of injury due to unwanted door travel
▶ See warning in section 6
Danger of injuries due to unintended door travel
See warning in section 6
▶
2.8 Approved safety equipment
The following functions or components, where available, meet
cat. 2, PL "c" in accordance with EN ISO 13849-1:2008 and
were constructed and tested accordingly:
Internal power limit
Tested safety equipment
If such properties are needed for other functions or
components, this must be tested individually.
Danger of injuries due to faulty safety equipment
See warning in section 5.1
▶
CAUTION
CAUTION
CAUTION
WARNING
CAUTION
WARNING
TR10K009 RE / 02.2016