Presettings Of The Hytronic Service Handy; Querying And Changing Settings - geberit HyTronic Instrucciones De Uso

HyTronic Service Handy, Unidirectional
Operation
Operation
Insert batteries before using the HyTronic Service
Handy for the first time.
The functions of the navigation buttons are
described under "Controls".
Output of values through LED signal
The control indicates saved values as a
confirmation or for reading. The values are
indicated through light impulses via the LED in the
sensor of the control. Wait for the buzzing signal of
the Service Handy, then start counting.
Numerical values (example)
LED flashes 7 times in a row (= digit 7)
short break
LED flashes 3 times in a row (= digit 3)
short break
LED flashes 6 times in a row (= digit 6)
The numerical value is 736.
The digit "0" is indicated by the LED briefly flashing
3 times (washbasin tap: LED briefly flashes once).
ON / OFF
LED flashes once = ON
LED briefly flashes 3 times = OFF
Presettings of the HyTronic
Service Handy
• [Buzzer] [Summer]
Buzzing signal volume
• [Contrast] [Kontrast]
Set display contrast
• [Version] [Version]
Display software version of Service Handy
• [Language] [Sprache]
Change menu language English [EN] / German [DE]
1 Switch on HyTronic Service Handy; the following
information is displayed:
GEBERIT
00 Bidirect
08 Unidirect
Settings
2 Go to [Settings] [Einstellung] and press "OK".
GEBERIT
Settings
00 Bidirect
08 Unidirect
30
GEBERIT
00 Bidirekt
08 Unidirekt
Einstellung
GEBERIT
Einstellung
00 Bidirekt
08 Unidriekt
3 The following information is displayed. Now select
the settings to be changed.
.0 Back
.1 Buzzer
.2 Contrast
.3 Version
There are different types of menus that require
different operation. See "Operation of menu types
A, B, C, D".
4
Desired settings are made. Go to [Back][Zurück]
and press "OK".
The following information is displayed:
GEBERIT
00 Bidirect
08 Unidirect
Settings
5 Switch off HyTronic Service Handy.

Querying and changing settings

Prerequisites
• Control is installed correctly and operating
A menu item can be exited at any time by pressing
"Esc".
If the contact is not ended after the operation is
finished, the control remains inactive for ten
minutes before it ends the contact automatically.
Always wait until the LED in the sensor stops
flashing before entering any settings.
For washbasin taps, first cover the sensor window
with your thumb until the water stops flowing and
the LED flashes repeatedly.
1 Switch on HyTronic Service Handy outside of
detection range of control; the following
information is displayed:
GEBERIT
00 Bidirect
08 Unidirect
Settings
2 Go to [Unidirect] [Unidirekt] and press "OK".
GEBERIT
08 Unidirect
Settings
00 Bidirect
.0 Zurück
.1 Summer
.2 Kontrast
.3 Version
GEBERIT
00 Bidirekt
08 Unidirekt
Einstellung
GEBERIT
00 Bidirekt
08 Unidirekt
Einstellung
GEBERIT
08 Unidriekt
Einstellung
00 Bidirekt