Clothing And Equipment; Transporting The Machine; Before Operation - Viking GB 370 S Manual De Instrucciones

Any spilt fuel must be wiped up
immediately.
Clothing must be changed if it comes into
contact with petrol.
Never store the machine with petrol in the
tank inside a building. The resulting petrol
fumes could come into contact with naked
flames or sparks and could be ignited.
If it is necessary to drain the tank, this must
be done out of doors.

4.3 Clothing and equipment

Always wear sturdy footwear
with high-grip soles when
working. Never work barefoot
or, for example, in sandals.
Also always wear sturdy gloves
when working and in particular
also when performing
maintenance operations or

transporting the machine.

Always wear safety glasses and
hearing protection when
working. Wear them at all times.
Wear suitable, close-fitting
clothing when working with the
machine, e.g. overalls, but not
work coats. Do not wear
scarves, ties, jewellery, clothing with
dangling straps or cords or other
protruding articles of clothing when
working with the machine.
Long hair must be tied up and secured
(headscarf, cap, etc.) at all times when
operating or performing work on the
machine.
30
4.4 Transporting the machine
Always wear gloves in order to prevent
injuries due to sharp-edged and hot
components.
Do not transport the machine with the
engine running. Switch off the engine, let
the blades come to a standstill and remove
the spark plug socket prior to transport.
Only transport the machine once the
engine has cooled down and with an
empty fuel tank.
Only transport the machine with the feed
chute properly fitted
Risk of injury due to exposed blades.
Pay particular attention to the weight of the
machine, especially when tilting.
Use suitable loading aids (loading ramps,
lifters).
Secure the machine on the load floor using
adequately dimensioned fastening
material (straps, ropes etc.) at the
fastening points described in this
instruction manual. ( 13.3)
Push or pull the machine at walking pace
only. Do not tow!
When transporting the machine, always
observe regional legislation, especially
regarding load security and the transport
of objects on load floors.

4.5 Before operation

Make sure that only persons who are
familiar with the instruction manual are
permitted to use the machine.
Check the fuel system (particularly visible
parts such as e.g. tank, tank cap, hose
connections) before operating the
machine. In the event of any leaks or
damage, do not start the engine – fire
hazard!
Have the machine repaired by a specialist
dealer prior to operation.
Observe the local regulations regarding
permitted operating times for gardening
power tools with combustion engines or
electric motors.
Defective and all other worn or damaged
parts must be removed before using the
machine. Replace any illegible or
damaged danger signs and warnings on
the machine. Your VIKING specialist has a
supply of replacement stickers and all the
other spare parts.
Before initial operation, it must be ensured
– that the covers and guards are in place
and in good condition
– that all fuel-carrying components are
fitted to the engine and are in good
condition (leak-tight)
– that the tank is in good condition (leak-
tight)
– that the housing and cutting tools
(blades, blade shaft, blade discs, etc.)
are not worn or damaged
– that there is no shredding material in
the machine and that the feed chute is
empty
– that all screws, bolts, nuts and other
fastening elements are in place and
properly tightened. Tighten any loose
screws, bolts and nuts prior to initial
operation (observe tightening torques).
Only use the machine out-of-doors and not
close to walls or any other solid objects in
order to prevent the risk of injuries and
property damage (no escape for the user,
broken windows, scratched cars etc.).
0478 216 9901 D - EN